Creative MovieFX v2 Forum


box Creative MovieFX v2
Creative MovieFX v2 is a Flash effects component that offers the ability to apply effects on any movie clips. From the user friendly interface it?s very easy to browse the over 280 predefined effects gallery and apply them on the three transition types available (In effects, Out effects, and Wait effects) without writing a line of code.

Find out more about Creative MovieFX v2

Thread: MovieFX animate only on a small area

back
Add Post
title left
User Details
message
title right
Subagio Rasidi Kusrini

post date:
2007-04-29 03:58:07
Hi

I'm trying to make a simple Flash with my underwater picture and used your MovieFX

First I imported the JPG-picture (500x335 pixel) to the library and converted it to a movieclip, put the Creative MovieFX on it and launch the compont inspector (Category : All, Efect : PieceDance).

Unfortunately the MovieFX animated only on a small area on the bottom right side (ca. 1/4 of the picture).

On other effects, I see that the MovieFX animated with the whole area of the picture, some test I made with category : All, Efect :
Bounce
ColorMe
DarkTint
Elastis
Fade
Impact
ImpactBounced
Imprint
ImprintBounced etc.

How can I get the effect to the whole area of the picture or did I make a mistake during importing the picture to the library ?

Could you please help me with some tips to resolve this .
I will send you the FLA-file with email.

Best regards
etoy
Horea Radu [Extend Studio]

post date:
2007-04-29 17:23:27
Hi,

The problem was that the registration point of your movie clip was not set properly. When using MovieFX you have to set the target movie clips registration point to the upper-left corner of the movie clip.

I have sent you the corrected FLA file by email.

Best regards,
Horea RADU.
Subagio Rasidi Kusrini

post date:
2007-04-30 05:14:26
Hi Horea,

Thanks for your reply.
It work fine now and I can continue my work with MovieFX

Best regards
Subagio Rasidi Kusrini (etoy)
Greg Fry

post date:
2007-07-20 18:01:27
I'm having the same problem - the effects are only applied to the bottom right area of the Movie Clip. Then, after the effect is complete, the whole image appears. But, making the registration point fix did not fix the problem. My image and Movie Clip both have their registration points set at the upper left. no change. Any other suggestions?
Catalin Serban [Extend Studio]

post date:
2007-07-23 02:31:00
Hello Greg,
It will be great if you can send us the *.FLA at support (@) extendstudio (dot) com.

Best Regards,
Catalin Serban
back
Add Post